Installation Of The Ew7016; Windows 2000/Xp/Vista/Windows 7; Connecting A Hard Disk Or Cd-Rom/Dvd Player; Connecting An Ide Hard Disk Or Ide Cd-Rom/Dvd Player - Ewent EW7016 Mode D'emploi

3.0 Installation of the EW7016

3.1 Windows 2000/XP/Vista/Windows 7

From Windows 2000 and up, Windows has built-in drivers for the EW7016. When
using these Windows versions there is no need to install drivers. Windows will install
the correct driver(s) automatically the moment you connect the hardware. Refer to the
following chapter for detailed information how to connect the EW7016.
4.0 Connecting a hard disk or CD-ROM/DVD
player
We recommend that you make a backup of the hard disk you wish to use. Ewent can
not be held responsible should any loss or damage of data occur resulting in the
installation or use of this device. Ewent advises you to disconnect the EW7016 from
your computer before connecting a hard disk, CD-ROM or DVD player.
4.1 Connecting an IDE hard disk or IDE CD-ROM/DVD
player
If you use an IDE hard device, you have to set the hard disk to 'Master'. Refer to the
label on your hard disk or CD-ROM/DVD player for more information on these
settings.
1. Connect the power cable to the power converter.
2. Connect the IDE power cable to the power converter.
3. Connect the other side of the IDE power cable to the power connection of the
IDE disk or CD-ROM/DVD player (Molex).
4. Connect an IDE cable to the IDE hard disk or CD-ROM/DVD player.
5. If you are using a 2.5 inch IDE hard disk: Connect the other side of the IDE cable
to the 2,5 inch IDE connector of the EW7016 (1.). In case you are using a 3.5
inch IDE hard disk: Connect the IDE cable to the 3.5 inch IDE connector of the
EM1016.
6. Connect the USB 3.0 cable to a free USB (3.0) port of your computer.
7. Connect the small plug of the USB 3.0 cable to the USB connection of the
EW7016.
8. Connect the power adapter to a wall outlet.
The 'Wizard New Hardware' may appear. Should you see the following message:
9.
'Is Windows Allowed to make a connection to Windows Update to search for
software?', select 'No, not now'.
10. Click 'Next'
11. Select 'Install the software automatically (recommended)'.
12. Click 'Next' and follow the steps shown on screen.
13 |
ENGLISH