General Safety Rules; Operating - Jay Electronique Jump Notice D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1 - General safety rules

IMPORTANT :
When installing, be sure to take account of the 100ms processing delay which
you must add to the total passive stopping time of the system. See
principle» section.
Before use, you must configure the radio channel on which the repeater will
be operating. See «Configuration» section.
!
It is essential to «learn» the identity code of the equipment with which the
repeater Jump will be used. See «Configuration» section.
If several « transmitter / repeater Jump / receiver » systems must be installed
!
in the same area, it is mandatory to configure them with different working
(receiving) frequency channels. See «Configuration» section.
Only use one repeater Jump within a «transmitter / receiver» pair, if the
!
transmission frequency is the same as the reception frequency.
except otherwise recommended. See
This rule must be applied to keep the emergency stop function.
It is possible to use several repeaters Jump for a «transmitter / receiver» pair.
!
In this case, the reception frequency and the transmission frequency of the
repeater must be different. See «Configuration» section.
This rule must be applied to keep the emergency stop function.
 Service your equipment and perform all the periodic checks as
may be required by the intensity with which your equipment is used.
FR
EN
- 44 -
«Operating
principle» section.
«Operating
Jump - 332970E_A005
04/03/21

Publicité

Chapitres

Table des Matières
loading

Table des Matières