Applications; Installing/Removing Battery Pack - Ryobi P3370 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
Ensure that the drain plug is securely in place and the
product does not leak water when filling the cooler. Do
not overfill. Leaks can result in a slippery surface and
create a slip and fall hazard.

APPLICATIONS

You may use this product for the purpose listed below:
 Outdoor cooling
FILLING THE COOLER WITH ICE
See Figures 1 - 2, page 8.
The cooler has a 50 quart capacity and may be filled to the
top with ice for best performance.
WARNING:
Never use dry ice in the cooler. Use only ice made
from clean water. Contact with dry ice can cause serious
personal injury and damage the unit. Dry ice can also
displace oxygen and cause a suffocation hazard.
 Make sure the drain plug is securely in place.
 Open the cooler and install the cooling tower as shown.
 Fill the cooler with ice, making sure the cooling tower
stays in place.
 Securely close the cooler lid.
WARNING:
Be sure to keep fingers out of the way when closing the
lid. Closing the lid on fingers or getting them too close
to the hinge area can cause a pinch hazard and result in
serious personal injury.

INSTALLING/REMOVING BATTERY PACK

See Figure 3, page 8.
 Securely close the cooler lid.
 Lift the latch to open the battery compartment.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
OPERATION
OPERATING THE COOLER
See Figure 4, page 8.
WARNING:
Only move the cooler by lifting the handle and pulling
the cooler on its wheels. Do not tilt or tip over appliance;
tilting or tipping unit can cause water to spill, resulting in
possible electric shock, slip and fall hazard, or property
damage.
WARNING:
Keep water away from all electrical devices to reduce the
risk of electrocution or electric shock.
WARNING:
Do not use the cooler to disperse liquid medicines,
chemicals, or other liquids. These substances could
result in serious injury or illness to the operator or
bystanders.
 Pressing the power button will turn the cooler on or off.
 Adjust the vent on the front of the cooler to direct cool
air to the desired area.
NOTE: The cooler will only turn on when the lid is closed. If
the lid is opened, the cooler will shut off.
DRAINING THE COOLER
See Figure 5, page 8.
WARNING:
Be careful not to spill water when draining the cooler. Do
not empty water on a walkway and only empty in an area
that will not cause a slip and fall hazard. Spilled or leaking
water can result in a slippery surface, create a slip and
fall hazard, and cause property damage.
 Move the cooler to an appropriate area for draining the
unit.
 Remove the drain plug and allow all water to drain out.
 Reinstall the drain plug.
WARNING:
Always completely drain water and thoroughly dry the
cooler after use to prevent the possible formation of
bacteria or mold. Using a cooler that contains bacteria
or mold can result in serious personal injury or illness.
6 — English

Publicité

Table des Matières
loading

Table des Matières