Craftsman CMXGZBF7124533 Guide D'utilisation page 6

ENglISh
Step 5: (fig. 5)
1. Assemble the boom mount bracket to the rear of the
frame tubes using two 5/16" x 2" hex bolts (A) and 5/16"
nylock nuts (F).
Fig. 5
5/16" x 2"
HEX BOLT (A)
Step 6: (fig. 6)
1. Assemble the boom bars to the boom mount bracket
using two 5/16" x 1-1/4" carriage bolts (C), tooth lock
washers (J) (between the bar and bracket), 5/16" flat
washers (G) and knobs (N). The boom connecting hose
should extend upward.
2. NOTE: Make sure the nozzles are adjusted so that the
openings face straight down when the boom bar is in
the horizontal operating position...
Fig. 6
BOOM CONNECTING HOSE
5/16" FLAT
WASHER (G)
KNOB (N)
BOOM BAR
CARRIAGE BOLT
5/16" x 1-1/4" (C)
4
5/16" NYLOCK NUT (F)
WASHER (J)
(TOOTH LOCK)
Step 7: (fig. 7)
1. Assemble the small (O) spray gun clips to the side of
the tank using two #10 x 1/2" screws (D) and #10 lock
washers (I)
Fig. 7
#10 x 3/8"
SCREW (D)
#10 LOCK
WASHER (I)
Step 8: (fig. 8)
1. Insert a garden hose gasket (T) into the swivel nut on
the bypass/return hose. Screw the nut onto the upper
outlet of the "Y" valve fitting. Place the other end of the
hose down through the hole at the rear of the tank.
2. Insert a garden hose gasket (T) into the swivel nut on
the boom connecting hose. Screw the nut onto the
lower outlet of the "Y" valve fitting.
3. Slide the coiled hose clamp (S) onto the spray gun hose.
Push the hose onto the hose adapter on the side of
the "T" fitting as shown in figure 8. Tighten the clamp
around the hose and the adapter. Snap the spray gun
into the clips on the side of the tank.)
Fig. 8
BYPASS/RETURN HOSE
SPRAY
COILED
GUN
HOSE
HOSE
CLAMP (P)
BOOM CONNECTING HOSE
Hose Clip (Small)
SPRAY GUN
CLIP (O) (SMALL)
GARDEN
HOSE
GASKET (T)