Install Shelves; Install Leveling Legs - Whirlpool Gladiator Garageworks GALG36KDESG Instructions D'assemblage

6. Using the hex key (provided), completely tighten all 24 cabinet
bolts and nuts.
P1
P3

Install Leveling Legs

1. Place the cabinet on its side.
2. Screw a leveling leg (P4) into each of the four rivet nuts located at
the corners of the cabinet as shown.
P1
P3
A. Leveling legs
3. Stand the cabinet upright.
4. If you have not already, fasten the two bolts at each front corner,
of the cabinet frame. Completely tighten all the cabinet bolts and
nuts.
4
P2
P1
P4
A

Install Shelves

F3c
F3c Phillips-head screw (12)
F5 Small flange nut (12)
IMPORTANT: Use the pair of holes located in the middle of the
cabinet sides to install a center shelf without the magnet (P5), so the
doors will lock. The other two shelves with magnet (P5m) may be
installed where desired.
1. Place the shelf (P5) without the magnet in the cabinet so that the
long edge with the two holes is facing out.
2. Align the holes in the shelf ends with the pair of holes in the
middle of the cabinet sides (P1).
3. Using two screws and nuts per side, fasten the shelf (P5) to the
sides (P1).
P1
A
A. Middle pair of holes in cabinet side
4. Determine where you want to place the other two shelves with
magnet (P5m). Align the holes in the shelf ends with the holes in
the cabinet side.
NOTE: Make sure the magnets in the long edges of the shelves
are facing the cabinet front.
5. Using two screws and nuts per side, fasten the shelves with
magnet (P5m) to the cabinet sides (P1). Completely tighten the
nuts.
F5
P2
P5m
P1
P5
P5m
P3