Get started!
EN
You're on your way to a fresher, smoother skin! Treating with Skinera
Microdermabrasion is easy. Just follow these steps for each area
you wish to treat. A total treatment should take around 5 minutes.
Recommended precautions
•
Before you treat an area for the first time, do a spot test
on a small area of skin. If you have no adverse reaction, go
ahead and treat that area.
•
Use the low suction mode for your first 2-3 treatments.
•
We recommend you do not use the device more than twice
a week.
• Stop immediately if you feel any discomfort.
Treatment steps
1.
Make sure your skin is clean, dry and free from powder,
cream or gel.
2.
Make sure that the rubber cap (#2), filter (#3), and tip (#1)
are firmly in place. For your first few treatments, be sure to
use the Fine tip.
3.
Press the control button (#4) to turn on the device. Your Skinera
Microdermabrasion is ready for use in low suction mode.
4.
Apply the tip firmly to your skin so that you feel the suction.
5.
Work each area as recommended in section "Treatment areas".
6.
To move from low to high suction mode, press the control
button again.
7.
To switch off the device after treatment, short press the
control button once or twice, depending on which suction
mode you are in.
8.
Unplug the device and store Skinera Microdermabrasion in its
original box. Please refer to section "Maintenance and storage".
10