Makita TM3010C Manuel D'instruction page 6

To remove the holder bolt, follow the installation proce-
dures in reverse.
4
► 1. Holder bolt 2. Holes in the application tool
3. Adapter 4. Protrusions of the tool flange
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
OPERATION
WARNING:
• Before starting the tool and during operation,
keep your hand and face away from the applica-
tion tool.
CAUTION:
• Always hold the tool firmly with one hand on
housing. Do not touch the metal part.
• Do not apply excessive load to the tool which
may cause a motor lock and stop the tool.
Cutting, sawing and scraping
CAUTION:
• Do not move on the tool forcibly in the direction
(e.g. towards either side) of tool application with
no cutting edge. It may damage the tool.
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
3 2
NOTE:
• Forcing or excessive pressure on the tool may
reduce efficiency.
• Remove sawdust by drawing tool adequately. It
increases work efficiency.
• Before cutting operation, it is recommended to
preset the orbital stroke rate 3 - 5.
1
• The round saw is recommended for cutting long
straight line.
Sanding
CAUTION:
• Do not reuse a sanding paper used for sanding
metal to sand wood.
• Do not use a worn sanding paper or sanding
paper without grit.
Apply a sanding paper on the workpiece.
NOTE:
• Using a test material sample to try is recom-
mendable to determine a correct orbital stroke
rate suitable for your work.
• Use a sanding paper with the same grit until
sanding the whole workpiece is completed.
Replacing a sanding paper with different grit
sanding paper may not get a fine finish.
6 ENGLISH