Carat CARACOUP Mode D'emploi page 21

b- the cutting depth with the locking lever (See
picture 8);
c- the straight cut measurement with the tile
bearing square as well as the ruler placed on
the working table (See picture 6);
d- the cutting adjustment with the specially
provided indicator and ruler placed on the slide
rail.
8 8
In order to carry out special working it is possible to
set out any cutting inclination ranging from 0° to 45°
as marked on the machine side (See picture 9).
9 9
CAUTION !
BEFORE ANY CUTTING MAKE SURE THAT THE
TILE TO BE CUT IS PROPERLY LEANED
AGAINST THE TILE-STOPPER.
9. Maintenance
CAUTION !
DISASSEMBLY OF THE DIAMOND BLADE
Loosen the two nuts on the blade guard and remove it.
Remove the blade fixing nut with a 19 mm wrench
and a 5 mm Allen key.
1 1 0 0
CAUTION !
THE BLADE FIXING NUT HAS A LEFT-HAND
THREAD.
After dismantling the blade, clean the blade flanges
carefully and check them for wear.
Grease any surface with fine oil and go on with the
assembly of a new blade. Check for correct
direction of rotation as clearly indicated on the tool.
CAUTION !
MOTOR CARRIAGE ADJUSTMENT
The motor carriage is provided with a register for the
vertical play adjustment. If any excessive play of the
motor carriage should take place, act as follows:
1) Loosen the register fixing nut with a 10 mm
wrench;
2) Screw down the dowel with a 4 mm Allen key
until the play is eliminated;
3) Lock the register again with the fixing nut.
1 1 1 1
21
GB