Table des Matières
Publicité
GB
Oberon Lo / Oberon Hi
User manual
Thank you for purchasing the Lightpro Oberon.
This document contains the required information for
correct, efficient and safe use of the product. Consult
the general manual of the Lightpro 12-volt system
and the user manual of your transformer for more
information about the set up and connection of your
light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Oberon is a standing LED lamp for
outdoor use. The fixture can be mounted on a solid
surface or placed in the ground with the supplied spi-
kes. This product may only be used as outdoor lighting
in combination with the Lightpro 12-volt system. Any
alterations made to the product may have consequen-
ces for the safety, guarantee and correct functioning of
the product and/or other parts of the system.
Specifications
Product
Article number
Power
Luminous flux
Dimensions (h x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
INSTALLATION
Packaging content
[Figure A]
1. Fixture Oberon Lo/Oberon Hi
2. Ground spike
3. Screw
4. Screw
5. Plug
6. Lightpro connector
7. Hex key
Lightpro Oberon Lo / Hi
190P / 191P
4W
400 lm
420 / 660 x 64 mm
IP44
-20°C to 50°C
1m
Yes
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
Installation
[Figure B]
Remove the screws [8] from the fixture [1] using the
included hex key [7]
[Figure C]
Haal de voet [9] uit het armatuur [1]Remove the base
[9] from the fixture [1]
Option 1: Placement in the ground
[Figure D]
Fasten the spikes [2] to the base [9] with the included
screws [3]
[Figure E]
Place the base [9] in the fixture [1]
[Figure F]
Put the screws [8] back in the fixture using the hex key [7]
[Figure G]
Place the fixture in the ground
Option 2: Placement on a fixed underground
[Figure H]
Mount the base [9] on the underground using the
included screws [4]
If necessary, drill holes in advance and use the
included plugs [5]
[Figure I]
Place the fixture [1] on the base [9]
[Figure J]
Put the screws [8] back in the fixture using the hex key [7]
[Figure K]
Ready
Operation of the Dimmer
[Figure L]
Unscrew the head [10] and remove it from the fixture [1]
[Figure M]
Set the desired brightness using the push button on
the underside of the head [10]
The brightness can be adjusted to 6 different levels
[Figure N]
Put the head [10] back in the fixture [1] and fasten it
Publicité
Table des Matières
