ECG EV 1510 Mode D'emploi page 27

Table des Matières

Publicité

8. Do not use the appliance outside or in a wet environment and do
not touch the power cable or the appliance with wet hands. Risk of
electric shock.
9. Make sure that the double hot plate is placed on a stable, secure
surface to prevent it from overturning or to prevent water from
entering it.
10. We do not recommend using extension cords. They could overheat
and cause fire. If it is necessary to use an extension cord, the
crosssection of the cable wires should be 1,5 mm
the NO.14AWG standard.
11. To prevent overloading and blowing fuses, make sure that there is
no other appliance with high power consumption connected to the
same outlet or on the same circuit.
12. DO NOT PLACE the power cord under a rug or a blanket. Do not
step on the power cord.
13. Do not allow the cord to touch hot surfaces or lead the cord over
sharp edges.
14. Pay close attention when handling the appliance to prevent injury,
for example, burning, scalding.
15. Do not use the hot plate close to flammable
objects or underneath them, e.g. close to
curtains. The temperature of surfaces near
the operating appliance is hotter than usual.
Place the hot plate away from other objects
to provide necessary distance. Do not put
any objects on the hot plate, avoid risk of
burns.
16. Disconnect the cord from the electrical outlet prior to performing
maintenance. When disconnecting the power cable, pull the plug,
not the cable.
17. When cooking, do not use oil spray, use basting brush soaked
in oil. Be especially careful, because oil and fat can ignite when
overheated. When heating cans or other closed containers, always
or conform to
2
Surfaces marked this
way become hot
when used.
GB
27

Publicité

Table des Matières
loading

Table des Matières