Exo Terra Monsoon RS400 Mode D'emploi page 4

C
8. Close the remaining inlets by sliding the slider against the
tubing or wires to prevent escape from feeding insects and
smaller animals. (fig. C)
9. Remove any slack in the tubing inside the terrarium. Make sure
there are no kinks in the tubing which would impede water flow
to the nozzles. Verify that the suction cups are properly attached.
D
6
10. Connect the tubing from the nozzles to the Y-connector by
pressing the tubing firmly into one of the side-by-side holes as
far as possible. Connect both nozzles. (fig. D)
E
11. Connect the tubing to the remaining hole of the Y-connector by
pressing it firmly inside as far as possible. (fig. E)
12. Place the Monsoon RS400 unit on a solid, level surface.
F
13. Connect the tubing coming from the Y-connector to the top of
the unit by pressing the tubing firmly into the connector on top
of the control unit. (fig.F)
14. Make sure that the filter is properly connected to the spigot on
the underside of the control unit and placed inside the reservoir.
15. Ensure that the top of the Monsoon RS400 unit fits tightly on top
of the reservoir.
G
16. Open the small lid on top of the unit, and fill the reservoir with
de-mineralized/distilled water up to a maximum of 2,5 cm (1")
from the top rim of the transparent reservoir. (Using regular tap
water will cause clogging of the nozzles by mineral deposits!)
(fig. G)
17. Close the lid and connect the power supply jack to the back
of the unit.
18. Make sure the unit is in its final operating location, on a solid,
level surface.
19. Plug the power adaptor into the wall socket, your Exo Terra
Monsoon RS400 High-pressure Misting system is now ready to
use. In order to remove the tubing from either the Y-connector
or the unit, press and hold the blue ring down, while pulling out
the tubing. Please note that each nozzle also can be mounted in
different terrariums.
®