Setting Up The Transmitter - Audiovox AWD204 Manuel De L'utilisateur

G
ettInG

Setting Up the Transmitter

The 900MHz wireless transmitter works with a wide variety of audio
sources, from portable MP3 players to A/V receivers to DVD players or
gaming systems. The way you set it up depends on the kind of output
you want to use on your audio source.
To connect the transmitter to your audio source:
3
Transmitter (back panel)
If your audio source has stereo RCA
outputs: Connect the red and white plugs
of a stereo Y adapter cable (not included) to
the audio source's line out jacks. Connect the
other end of the stereo Y adapter cable to the
transmitter's built in audio cable.
6
S
tarted
1
2
1. Plug the transmitter's
built in audio cable into
the headphone jack on
your audio source.
2. Connect the AC power
adapter to the Power In
jack on the transmitter's
back panel.
3. Plug the adapter into an
electrical outlet.
Important: This power
unit is intended to be
correctly oriented in a
vertical or floor mount
position.
Note: High output sources,
such as DVD players or
audio receivers/amplifiers,
may cause distortion if
used at full volume with the
transmitter. Try setting them
at 1/2 or 2/3 volume.