Technical Specifications - Tasco 5TN Manuel Du Propriétaire

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

INSTRUCTIONS FOR TELESCOPE MODELS 5TN / 49TN / 45T / 54TN

1. Remove tripod (N) from box.

2. Stand tripod and spread legs.

3. Remove telescope main body (I) from the box. Unscrew mounting bolt (B) from telescope base

(5TN/49TN/45T) or remove from the box (54TN). Place telescope onto tripod mount (Fig. 1).

Insert bolt through tripod mount (Fig. 1c) and tighten securely.

4. Remove the finderscope (Fig. 1a) from the box. Place the finderscope (H) in the finderscope

bracket (G) and secure with three finderscope bracket set screws.

5. Model 5TN/49TN/45T: Insert diagonal into the focus tube (Fig. 4m). Secure by tightening small

retaining screws.

6. Model 5TN/49TN/45T: Use the micro-altitude adjusting knob (Fig. 1d) and the azimuth adjusting

knob (Fig. 1e) in the tripod mount to move the telescope as desired.

NOTE: Diagonal is only to be used in combination with the eyepieces (oculars).

7. Model 5TN/49TN/45T: Insert eyepiece (Fig. 4k) into diagonal (Fig. 4m). Secure by tightening

small retaining screw.

NOTE (5TN/49TN/45T): In all astronomical telescopes, the image appears upside down. With

the use of the diagonal the image appears erect but with a left to right inversion (mirror like).

To use the telescope for terrestrial viewing and to correct the mirrored image, remove the

diagonal and replace with the erecting eyepiece (Fig 6).

8. To obtain focus on model 54TN, push or pull the focusing tube (D) until the image is sharp

(Fig. 2).

The telescope is now fully assembled and ready for use.

CAUTION: Viewing the sun can cause permanent eye damage. Do not view the sun with

this product or even with the naked eye.

Objective Diameter

Focal Length

Eye Lenses

Erecting Eyepiece

Maximum

Magnification

Accessories

12.5mm Eye Lens

Power

18mm Eye Lens

Power