Noise Emission Values; Important Information For Initial Operation; Operation Instructions - erba 18058 Mode D'emploi

GB - INSTRUCTION MANUAL

6. NOISE EMISSION VALUES

See technical data.

7. IMPORTANT INFORMATION FOR INITIAL OPERATION

See operation instructions.

8. OPERATION INSTRUCTIONS

Inserting nails or staples:
Disconnect the machine from the air supply.
Push the magazine lock (3) and slide back the magazine cover.
Nails: Insert as shown in image A. Make sure the tips of the nails are facing down!
Staples: Insert as shown in images B/C
Select a working pressure of 5-7,5 bar depending on the material you are working with. Harder
wood types require more pressure than softer wood.
Press the safety lock (7) against the workpiece and pull the trigger to shoot a nail or staple into
the workpiece.
In case of jammed nails or staples (inside the nozzle of the machine) pull the front lock (5) open
and you should be able to remove the jam (D-F).
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 13
Changes, print, punctuation and other errors reserved!
Instruction manual
18058
Issue: 06/2017