Cutting Height Adjustment; Blade Maintenance - VITO GARDEN VIMR 1800 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
CUTTING HEIGHT
ADJUSTMENT
FIG. G
17
To obtain the desired cutting
height, the front and rear axles are
repositioned on the underside of the
mower housing, with a handle.
WARNING: Disconnect the
mower from the power supply
and ensure the blade has stopped
coasting before adjusting the height.
STARTING
FIG. H
16
On/Off switch
16
Caution! Do not start the mower if
it is standing in long grass.
Press the safety button of the switch
assembly and then pull the switch
lever against the bar.
Keep the switch lever held whilst
releasing the safety button.
To stop the mower release the
switch lever and it automatically
returns to its off position.
MOWING
(Fig. N1 e N2)
2
3
4
1
N1
N2
We recommend using your mower
as outlined in this section in order
to achieve optimum results and to
reduce the risk of cutting the mains
cable.
Place the bulk of the mains cable on
the lawn close to the starting point.
Switch the mower on as described
above.
Proceed as shown in fig.N1.
Move from position 1 to position 2.
Turn right and proceed towards
position 3.
Turn left and move towards position
4.
Repeat the above procedures as
required.
Warning! Do not work towards the
cables as shown in fig. N2.

BLADE MAINTENANCE

(Fig. F).
Regularly remove grass and dirt
from the blade.
At the beginning of the gardening
season, carefully examine the
condition of the blade.
If the cable is very blunt, sharpen or
replace the blade.
If the blade is damaged or worn, fit
a new blade.
Warning! Observe the following
precautions:
Disconnect the mower from the
mains and wait until the blade had
stopped rotation before proceeding.
Be careful not to cut yourself. Use
heavy-duty gloves or cloth to grip
the blade (Fig. 19-H).
MAINTENANCE
Your mower has been designed to
operate over a long period of time
with minimum of maintenance.
Continuous satisfactory operation
depends upon proper mower care
and regular cleaning.
Keep the mower clean and dry.
Regularly use a blunt scraper to
remove grass and dirt from the
mower.
To clean the mower, use only mild
soap and a damp cloth. Never let
any liquid get inside the tool and
never immerse any part of the tool
into liquid. Do not use any abrasive
or solvent –based cleaner.

Publicité

Table des Matières
loading

Table des Matières