CARVIN Gold Série Manuel Du Propriétaire page 46

2.7 Spread the rock dust on the rim of the circle to a width
of 24" (2') all around including 12" outside and 12 inches
inside the rails location. The thickness of the rock dust
should be around 2 to 3".
2.8 Damp and pack down the rock dust of the perimeter
with your compactor. Once this is done, measure the
level and atness to ensure that the pool will rest on a
straight surface without space under bottom plates
or/and rails.
2.9 Place bottom plates and rails around the perimeter
and assemble together. Do not push the rails completely
in bottom plates. The rail has a graduated scale at each
end, begin by placing to the number 5 which will give you
approximately ½" to 5/8" of space between the center of
the plate and the end of the rail. The spacing of both rails
into each bottom plate should be equal at all times.
Number 5
2. THE FOUNDATION
Foundation line or rail location
(12" exterior)
Approx. 1/2" à 5/8''
(Equal on both sides)
12" interior
Pool size
Foundation line
bottom plates
(continued)
Rails and
(12' pool as example)
44.