Gtech Power Floor K9 Manuel D'utilisation page 44

Removing and cleaning the brush bar
Remove the extension floor tube from the
Power Floor K9 by pulling gently on the
green locking ring.
Rotate the latch on the side of the powered
floor head and pull out the brush bar.
44
2504_Powerfloor_manual_EcoFort_aw.indd 44
Before you remove the brush bar, you will
need to remove the power floor head from
the extension floor tube. To do this, gently
pull on the green locking ring.
To remove hair from the brush bar, run an
open pair of scissors down the groove to
cut the hair, then pull it out.
Never operate the power floor head without
the brush bar in.
31/01/2018 09:16