Overview; Setup; Attachment - EuroLite EDX-1 Mode D'emploi

4.2 Overview

5. SETUP

5.1 Attachment

Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: The hole for the installation is on the baseplate.
Step 2: Hold the baseplate onto the location where the device is to be installed.
Step 3: Mark the borehole with a pen or a suitable tool.
Step 4: Drill the hole.
Step 5: Hold the baseplate in the desired position and tighten it.
Before taking into operation for the first time, the installation has to be approved by an expert!
1. Output socket
2. LCD-display
3. Menu-button
4. Up-button
5. Down-button
6. Power supply
7. Fuse
8. DMX-input socket
9. DMX-output socket
DANGER TO LIFE!
15/34 00026401.DOC, Version 2.1