Fitting The Batteries; Fastening The Chronothermostat Onto The Base; Chronothermostat Configuration - AVE CRONOTC1B Instructions D'utilisation

Connecting the external floor temperature probe
Connect the two wires of the external temperature probe to terminals A and B,
as shown in the figure.
Once connections are over, refit the terminal protection guard removed
previously.
TERMINAL
NOT USED
EXTERNAL
TEMPERATURE
PROBE

Fitting the batteries

Fit two long-life 1.5 V AA alkaline batteries into the back of the chronothermostat,
observe the specified polarity. After fitting the batteries the chronothermostat will
turn on automatically.

Fastening the chronothermostat onto the base

Press by hand the chronothermostat onto the base, make sure the multi-pole
connector fits properly. The chronothermostat will click into position.
Configuring the chronothermostat
Warning: The chronothermostat shall be configured by qualified
personnel only.
Chronothermostat configuration enables to customize the operating parameters.
To open the configuration program, proceed as follows:
1. Press the SET / PROG key [key 6]. The operating mode being currently used
will be temporarily stopped and it will be resumed automatically at the end
of programming.
3
2. Keep the SUMMER / WINTER switching key [key 10] pressed for about 5
2
seconds.
1
B
A
TERMINAL BLOCK
CRONOTC...B
41
ENGLISH