Domair BREEZE Manuel D'utilisation page 31

light up to indicate the selected speed.
7. STOP button: allows the appliance to
go into standby
8. TIMER button :
Press this button repeatedly to turn the
programmable timer on or off.
NOTE: the time that can be program-
med is from 1 am to 12 midnight. This is
displayed on the LED screen. The inter-
val is from 1 hour. To cancel the timer,
display «Co» on the screen using the
button.
stoP tiMeR : the stop timer button is
used to put the appliance into standby at
the end of the programmed time.
1. During fan operation, press the TI-
MER button to determine the required
time of operation.
2. Press the button repeatedly to display
the desired time.
3. Without the TIMER button being pres-
sed for a few seconds, the program-
med time is taken into account: the
timer is then activated.
4. At the end of the set time, the ap-
pliance will turn off automatically.
staRt tiMeR : The start timer is used
to turn the appliance on after the end of
the programmed time.
1. In standby mode, press on the TIMER
button successively to set the required
time.
2. Press the button repeatedly to display
the desired time.
3. Without the TIMER button being pres-
sed for a few seconds, the program-
med time is taken into account: the
timer is then activated.
Rev 0-02 12 19
4. At the end of the time set, the ap-
pliance will turn on automatically.
9. Infra-red commands reception win-
dow
10. Standby indicator light (indicates
that the unit is off but is connected to the
power supply)
11. Indicator light: NATURAL mode
12. Indicator light: MIST mode
13. Indicator light: weak ventilation
14. Indicator light: OSCILLATION mode
15. MIST button : allows the misting to
be turned on or off
16. OSCILLATION button: allows the
fan to oscillate horizontally. To stop os-
cillation, press the button again.
IMPORTANT : NORMAL, NATURAL
and NIGHT modes are only accessible
from the MODE button on the remote
control.
Fabriqué en Chine Page 31