Velleman NVR1 Guide D'installation Rapide page 4

• high compatibility and offsite backup:
compatible with all major IP cameras that are ONVIF certified
o
added NAS function to back up all kind of IP cameras on the internet
o
works with free Central Management System (CMS) software for offsite backup
o
• local and remote control completely independent
• HDMI video output resolution up to 1080P
• optional hard disk: HD500GB/S, HD1TB/S
• USB mouse: GE31010826101, GE31011039100, GE31030414100
• compatible with: CAMIP9, CAMIP11, CAMIP12, CAMIP13
• optional router: EM4542, EM4553, EM4570, PCRT1.
5. Overview
Refer to the illustrations on page 2 of this manual.
Front panel
1
POWER
2
ALARM
3
WAN
4
LAN
5 RECORD
6
USB port
7 HDD1/HDD2
8
mouse port
Back panel
9 AUDIO OUT
10 WAN
HDMI video output
11
port
12 LAN
13 DC 19V IN
14 power switch
6. Installing the Hard Disk Drive (HDD)
1. Obtain a suitable HDD (not incl.), type SATA (Serial Advanced Technology Attachment). The HDD must be
formatted.
2. Make sure to unplug the device from the mains before servicing and do not touch any electronic circuitry
to avoid electrostatic discharge.
3. Loosen the screws and remove the top cover.
4. Find the hark disk bracket in the NVR, and place the compatible hark disk in the bracket.
5. With the PCB side facing up, connect the hard disk to the power connector and the data connector.
6. Fasten the hard disk with the supplied screws, two for each side.
V. 01 – 23/03/2012
LED indicator: the NVR is switched on
LED indicator: an alarm event occurs
LED indicator: the NVR is connected to internet
LED indicator: the NVR is connected to the LAN
LED indicator: recording is on
Insert a compatible USB flash drive for video backup.
Note: For the list of compatible USB flash drives, refer to the full manual on the
CD-ROM.
LED indicator: up to two hard disks are installed in the NVR and connected well
Insert a compatible mouse.
Connect to an amplifier audio line-in.
Connect to internet via an 8P8C (RJ45) network cable
Connect to a monitor that supports high-definition video output (HDMI port).
Note: Use an appropriate adapter (not incl.) to connect a monitor with VGA or
composite connectors.
Connect to local IP cameras via an 8P8C (RJ45) network cable.
Connect to the power supply adapter (incl.).
Switch the NVR on (—) or off (O).
NVR1
4 ©Velleman nv