Fan Assembly Instructions; Column Assembly Instructions; Fan Head Assembly; Convert Stand Fan To Floor Fan - Amana AF143CM1 Guide D'utilisation Et D'entretien

Stand and Floor Fan Assembly
A
B
C
D
E
G
F
H
A. Fan head arc support and tube assembly
B. Fan head assembly parts
C. Fan stand assembly parts
D. Height-adjustment screw
E. Base cover
Adjust Airflow
Back of the Fan Head
A
A. Fan speeds—oscillation on
B. Fan speed knob
C. Fan speeds—oscillation off
4

FAN ASSEMBLY INSTRUCTIONS

I
F. Screws (4)
G. Floor fan assembly
parts (some models)
H. Fan base
I. Floor fan—no
assembly required
FAN OPERATING INSTRUCTIONS
B
C

Column Assembly Instructions

1. Using the 4 screws (F), join the tubing part of the fan stand to
the fan base (H).
2. Loosen the height-adjustment screw (D).
3. Slide the base cover (E) over the tubing as shown.
4. Tighten the height-adjustment screw securely.
IMPORTANT: The height-adjustment screw must be fully
tightened before attaching the fan head to the fan stand.

Fan Head Assembly

1. Attach the tube to the fan head arc support (A).
2. Attach the fan head arc support and tube assembly to the fan
stand (B).
3. Insert the hand screw and tighten securely.

Convert Stand Fan to Floor Fan

1. Using the 4 screws (F), attach the floor fan assembly parts (G)
to the fan base (H).
2. Follow the directions in "Fan Head Assembly" to attach the
fan head assembly.
Floor Fan
NOTE: There is no assembly required for the floor fan.
Adjusting Airflow
1. To adjust the fan height, loosen the hand screw and raise or
lower the fan.
2. Retighten hand screw at desired height.
3. Move the fan head up or down, right or left, to the desired
position.
Oscillation
Rotate the fan speed knob to the Oscillation (left) side of the
control. Select 0 (Off), 1 (Low), 2 (Medium) or 3 (High) fan speed.
Speed Control—Oscillation Off
Rotate the fan speed knob to the Oscillation Off (right) side of the
control. Select 0 (Off), 1 (Low), 2 (Medium) or 3 (High) fan speed.