MAT Industries Sanborn 010-0016 Mode D'emploi page 5

To Clean Clogged Passages
1. Disassemble the air brush by using the following procedure (see figure 3):
a. Remove the retaining clip (Q) from the air brush body.
b. Screw the fluid cap (P) counterclockwise then push down to release the fluid needle (R).
c. Remove the fluid needle (R) by turning counterclockwise.
d. Clean the fluid needle (R), fluid cap (P) and air tip (O) with a piece of cotton dipped in thinner or
solvent. A fine bristled brush will also work.
e. Reassemble the air brush by reversing the above procedure. Note: Make sure that the flat surface of
the fluid needle (R) lines up with the flat surface of the air brush body (see figure 4).
NOTICE: Never use metal objects to clean precisely drilled passages. Damaged passages will cause
improper spraying.
Figure 3
SYMPTOM POSSIBLE CAUSES
Grainy Paint too thick
spray
Dried paint in the fluid needle or air tip
Buckling paper Paint too thin
Painting to heavily in one area
Paint blobs at Starting to spray before moving your
ends of stroke hand and stopping the movement before
shutting off the paint flow.
Flared ends Turning the wrist while airbrushing
Centipedes Spraying too much paint too close to the
surface
Splattering Permitting the trigger to snap back
Dried paint in the fluid tip or fluid needle
Curved stroke Caused by arching arm too close to the
surface
Restricted spray The fluid tip tightened too far counter-
clockwise
Bubbles through The fluid tip loosened too far clockwise
color cup
Color spray can- Fluid tip may be clogged; this is recog-
not be shut off nized by a "spongy" feel when the fluid
needle is set into tip.
Spitting Caused by residue on the fluid needle or
in the paint jar.
Paint may be too thick to operate
properly.
CLEANING INSTRUCTIONS (continued)
TROUBLESHOOTING
5 - ENG
Figure 4
CORRECTIVE ACTION
Add water, thinner or approved solvent (depending on
the paint used) sparingly to the paint.
Clean the airbrush. Refer to the "clean clogged pas-
sages" section.
Add pigment to thicken the mixture.
Move the airbrush more rapidly or lessen the spray.
Start motion before pressing the trigger and follow
through motion after releasing the trigger.
The whole forearm should move horizontally across the
surface.
Hold the nozzle of the air brush about 6 inches from the
surface.
Adjust the paint flow by turning the fluid cap.
Always release the trigger gently.
Clean the airbrush. Refer to the "clean clogged
passages" section.
Arm should always be parallel to work, unless this ef-
fect is desired.
Turn the fluid tip clockwise a turn or two.
Turn the fluid tip counter-clockwise a turn or two.
Clean the airbrush. See the "to clean clogged pas-
sages" section.
Clean the airbrush. See the "to clean clogged pas-
sages" section. Drain, wash and refill the jar with fresh
strained paint.
Add water, thinner or approved sol vent (depending on
the paint used) sparingly to the paint.