Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL ST 315 Instructions D'origine

6. Operation
Accessory slide used as an angle stop/cross
stop (Fig. 4)
•
The slide can be used as an angle stop/cross
stop in the same way as the universal stop.
•
Slacken the clamping lever (106).
•
Turn the stop rail (101) until the desired angle
is reached. 0° for use as a cross stop (90°
cuts) – a different angle for angle cuts.
•
Retighten the clamping lever (106).
•
Important! Do not push the stop rail too far
toward the blade (5). The distance between
the stop rail and the blade should be approx.
2 cm.
7. Operation
Making cross cuts (Figs. 4)
•
Set the cross stop or accessory slide to the
desired angle.
•
Press the workpiece firmly against the stop
rail (101).
•
Switch on the saw.
•
Push the cross stop or accessory slide and
the workpiece toward the blade in order to
make the cut.
•
Warning! Always hold the guided part of the
workpiece. Never hold the part which is to be
cut off.
•
Always push the cross stop or accessory
slide forward until the workpiece is cut all the
way through.
•
Switch off the saw again. Do not remove the
offcut until the blade has stopped rotating.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
Anl_ST_315_SPK9.indb 15 Anl_ST_315_SPK9.indb 15
GB
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
The reprinting or reproduction by any other me-
ans, in whole or in part, of documentation and
papers accompanying products is permitted only
with the express consent of the iSC GmbH.
Subject to technical changes.
- 15 -
11.03.2020 15:03:39 11.03.2020 15:03:39