Unused Battery Mode - Bosch BAT 131 Notice Originale

en �0 � B�T ��� � Unused Battery Mode
5.

Unused Battery Mode

The QC Test "Unused Battery" enables you to quickly
check new batteries in your inventory. The test can verify
up to 100 batteries in succession This test differs from
the Battery Test in that the decision is either pass or fail.
i
Neither decision will tell you that a battery is bad, but
rather that the measured voltage and CCA fall in or out
of your requirements.
1. Select UNUSED B�T. MODE from the Main Menu
and press E.
2. Select ON and press E.
3. The tester displays the total number of Inventory Tests
completed out of 100. Select Clear Memory to clear
the results from memory and reset the total to 0 or
select Add To Memory to add the results to memory.
!
Be sure to monitor the number of tests performed
and be ready to print the results as the number ap-
proaches 100. When the limit is reached you will no
longer be able to test until you clear all results from
memory.
4. Press E to continue.
5. �PPLIC�TION
Scroll to and select AUTOMOTIVE, MOTORCYCLE, or
MARINE.
6. B�TTERY TYPE
Scroll to and select STANDARD, AGM FLAT PLATE,
AGM SPIRAL, or GEL where applicable.
7. B�TTERY ST�ND�RD
Scroll to and select the battery's rating system. Not
all rating systems are available for each application.
Standard Description
CA Cranking Amps
CCA Cold Cranking Amps
MCA Marine Cranking Amps
EN Europa-Norm
EN2 Europa-Norm 2
DIN Deutsche Industrie-Norm,
German industry norm
SAE Society of Automotive Engineers, the
European labeling of CCA
IEC International Electrotechnical
Commission
JIS Japanese Industrial Standard, shown on
a battery as a combination of numbers
and letters.
|
1 689 989 132 2011-09-09
8. B�TTERY R�TING
Scroll to and select the rating units. Hold down the
 or  to increase the scrolling speed.
9. VOLT�GE LIMIT
Scroll to select the voltage limit to be used for the
test.
10. Press E to start test. After several seconds the
tester displays the
dition and the measured voltage. The tester also
displays your selected battery rating and the rating
units.
Fig. 2: Example of displayed results for a test of two batteries
i
Press  to print the test results or  to return to the
Menu.
Range
100-2000
100-2000
100-2000
100-2000
100-2000
100-1200
100-2000
100-1200
26A17 thru
245H52
decision on the battery's con-
Robert Bosch GmbH