To Stop The Product; To Start The Product; To Operate The Product - Husqvarna PP 492 Manuel D'utilisation

• Set time and date. Select the "SETTINGS" menu
and then the "TIME & DATE".
• Set the correct display language. Select the
"SETTINGS" menu and then "LANGUAGE".
• Set the necessary measurement units. Select the
"SETTINGS" menu and then "SET UNITS".

To start the product

1. Open the water supply to the product.
2. Turn the machine stop button on the product and on
the remote control clockwise to disengage.
3. Push the ON/OFF button to start the remote control.
This also starts the connected wall saw, information
is shown on the display. Refer to the operator's
manual for the connected wall saw for more
information.
4. If a PRIME tool is connected to the product, push the
ON/OFF button to stop the remote control. The
PRIME tool starts. Refer to the operator's manual for
the connected PRIME tool for more information.

To operate the product

• To operate the product, refer to the operator's
manual for the power tool.
14
OK
ON/OFF
0

To stop the product

WARNING:
supply to the product when it is not
connected to the power supply.
1. To stop the blade, turn the dial that controls the
speed counterclockwise to its 0 position.
2. Close the water supply to the product. If the water
coolant is set to "AUTO", the water supply will stop
automatically.
3. Stop the remote control unit, push the "ON/OFF"
button.
4. Push the emergency stop button to stop the product.
Always close the water
OK
ON/OFF
0
OK
ON/OFF
0
967 - 002 - 11.06.2021