Installing The Handle - Makita DLM380 Manuel D'installation

ASSEMBLY
WARNING:
• Always be sure that the lock key and battery
cartridge are removed before carrying out
any work on the mower. Failure to remove the
lock key and the battery cartridge may result in
serious personal injury from accidental start-up.
• Never start the tool unless it is completely
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the battery cover
WARNING:
• Do not insert the lock key and battery cartridge
before installing the battery cover. Failure to do
so may cause a serious injury.
Install the battery cover completely before operating the
tool to protect the tool and battery cartridge from mud,
dirt, or water.
1. Place the battery cover on the tool with aligning
the protrusions on the tool and the holes of the
battery cover.
3
► 1. Battery cover 2. Hole 3. Protrusion
2. Place your hands in the middle of the battery
cover and depress it.
► 1. Battery cover
1
2
3. Before the first operation, check that the pivot
point of the battery cover is assembled properly.
To check it, pull the battery cover locking lever
toward yourself and open the battery cover.
2
► 1. Battery cover 2. Pivot point 3. Battery cover
locking lever

Installing the handle

WARNING:
• When installing handles, position the wires so that they
are not caught by anything in between the handles.
1. Loosen the clamping screws (two pcs).
3
► 1. Lower handle 2. Clamping screw 3. Tighten
4. Loosen 5. Groove
2. Expand the lower handle to its both sides and with
it expanded in that position pivot it backward and
1
then fit it in the groove in the deck.
1
► 1. Lower handle 2. Upper handle 3. Holes
8 ENGLISH
2
4
3
3
1
3
1
5
2