GE Appliances GTS21 Serie Manuel D'utilisation Et Instructions D'installation page 17

Accessory
Ice Maker Accessory Kit:
WARNING
Connect to potable water supply only.
A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals)
cost.
"V" using the short (8") fill tube assembly, unless fill tube
is already installed.
To order, call GE Appliances at 800.GECARES
(800.432.2737) or visit GEAppliances.com
visit GEAppliances.ca or call 800.561.3344.
AUTOMATIC ICE MAKER
The ice maker will produce approximately 70-100
compartment temperature, room temperature, number of
door openings and other use conditions.
is made to the ice maker, set the switch OFF.
When the refrigerator has been connected to the water
supply, set the switch ON position.
A newly-installed refrigerator may take 12 to 24 hours to
begin making ice cubes.
Once the ice maker starts to make ice, it may take up
to 48 hours to fill the bin, depending on the temperature
settings and number of door openings.
49-60780-2 Rev. 4
OFF
ON
Power Switch
fills with water.
NOTICE: Throw away the first few batches of ice to
allow the water line to clear.
Be sure nothing interferes with the sweep of the feeler
arm.
When the bin fills to the level of the feeler arm, the ice
maker will stop producing ice.
cloudy, taste stale, shrink or fuse together.
CAUTION
Avoid contact with the moving parts
of the ejector mechanism, or with the heating element
(located on the bottom of the ice maker) that releases
automatic ice making mechanism while the refrigerator is
plugged in.
17