Engine Oil Filter Replacement - Yamaha EH64 Manuel Du Propriétaire

Oil filter
NOTICE
To prevent injury, pay attention to
the spilled hot engine oil when
replacing engine oil filter.
Knob
Urethane foam
Base
Air cleaner cover
Grommet
Element
ENGINE OIL FILTER
REPLACEMENT
■ Initial engine oil filter replacement should
be performed after 20 hours of operation.
Thereafter replace the engine oil filter
every 200 hours.
■ When installing a new oil filter, apply oil to
O-ring, attach the oil filter in position and
tighten 2/3 turns by hand or with wrench
after touching the O-ring to the sealing
surface of engine.
■ Run the engine for a minute ; stop the
engine and check for oil leakage around
the oil filter and recheck the oil level.
CLEANING AIR CLEANER
A dirty air cleaner element will cause
starting difficulty, power loss, engine
malfunctions, and shorten engine life
extremely.
Always keep the air cleaner element clean.
Replaced the air cleaner element set more
often in dusty environments.
The air cleaner paper inner element and
urethane foam outer element can be
removed after removing knob and air
cleaner cover. When installing, set the
paper element and urethane foam on the
air cleaner base. Check that the grommet is
in position, and then install the cover with
knob tightened securely.
■ Urethane Foam cleaning
Wash and clean the urethane foam in
kerosene. Saturate in a mixture of 3 parts
kerosene and 1 part engine oil, and then
squeeze to remove excess oil. Clean or
replace the urethane foam element every
50 hours. (more often in dusty
environments)
– 18 –