JVC Exad KD-AVX11 Manuel D'instructions page 52

Sound signals emitted through the rear terminals
Through the analog terminals (Speaker out/LINE OUT)
2-channel signal is emitted. When playing multi-channel encoded disc, multi-channel signals are downmixed.
• DTS sound cannot be reproduced.
Through the DIGITAL OUT terminal
Digital signals (Linear PCM, Dolby Digital, DTS, MPEG Audio) are emitted.
• To reproduce the multi-channel sounds such as Dolby Digital, DTS, and MPEG Audio, connect an amplifier or a
decoder compatible with these multi-channel sources to this terminal, and set <D. Audio Output> correctly.
(☞ page 41)
Playback disc
DVD 48 kHz, 16/20/24 bits Linear PCM
96 kHz, Linear PCM
with Dolby Digital
with DTS
with MPEG Audio
Audio CD, Video CD
Audio CD with DTS
DivX with Dolby Digital
with MPEG Audio
MPEG1/MPEG2
MP3/WMA
WAV
* Digital signals may be emitted at 20 or 24 bits (at their original bit rate) through the DIGITAL OUT terminal if the
discs are not copy-protected.
Characters shown on the monitor
In addition to the roman alphabet (A – Z,
a – z), the following characters will be
used to show the various information on
the monitor.
• You can also use the following
characters to assign titles. (☞ page 36).
Downloaded from Caradio-Manual.com Manuals
All manuals and user guides at all-guides.com
D. Audio Output
Stream
MPEG bitstream
DTS bitstream
Output signals
Dolby Digital
48 kHz, 16 bits stereo Linear PCM*
48 kHz, 16 bits stereo Linear PCM
Dolby Digital bitstream
DTS bitstream
48 kHz, 16 bits stereo Linear PCM
44.1 kHz, 16 bits stereo Linear PCM /
48 kHz, 16 bits stereo Linear PCM
48 kHz, 16 bits stereo Linear PCM
Dolby Digital bitstream
32/44.1/48 kHz, 16 bits Linear PCM
44.1/48 kHz, 16 bits Linear PCM
32/44.1/48 kHz, 16 bits Linear PCM
44.1 kHz, 16 bits stereo Linear PCM
Upper and lower cases
52
PCM Only
48 kHz, 16 bits stereo
Linear PCM
48 kHz, 16 bits stereo
Linear PCM
Numbers and symbols