Makita 4093D Manuel D'instructions page 4

ENGLISH
1 Rear cover
2 Battery cartridge
3 Switch
4 Nozzle
5 Cleaner body
SPECIFICATIONS
Model
Capacity ......................................................... 500 ml
Continuous use
(with battery 9000) ................ High: Approx. 13 min.
Overall length ............................................... 484 mm
Net weight ....................................................... 1.3 kg
Rated voltage ........................................... D.C. 9.6 V
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Safety hints
For your own safety, please refer to the enclosed
safety instructions.
ADDITIONAL SAFETY RULES
1. Read this instruction manual and the charger
instruction manual carafully before use.
2. Do not pick up wet materials, lit cigarettes or
the like.
3. Stop operation immediately if you notice any-
thing abnormal.
4. If you drop or strike the cleaner, check it
carefully for cracks or damage before opera-
tion.
5. Do not bring close to stoves or other heat
sources.
6. Do not block the intake hole or vent holes.
SAVE THESE INSTRUCTIONS.
4
All manuals and user guides at all-guides.com
Explanation of general view
6 Extension wand (Straight pipe)
7 Corner nozzle
8 Front cover
9 Depress
0 Open
OPERATING INSTRUCTIONS
4093D
Installing or removing battery cartridge
(Fig. 1 & 2)
• Always switch off the cleaner before insertion or
Low: Approx. 23 min.
removal of the battery cartridge.
• To remove the battery cartridge, remove the rear
cover from the cleaner by pushing it in the direction
of the arrow and then withdraw the battery cartridge
from the cleaner.
• To insert the battery cartridge, align the tongue on
the battery cartridge with the groove in the cleaner
and slip it into place. Then close the rear cover.
• Do not use force when inserting the battery car-
tridge. If the cartridge does not slide in easily, it is
not being inserted correctly.
Charging
Charge the battery cartridge with your Makita charger
properly before use.
Following batteries can be used for this cleaner;
Switch action (Fig. 3)
CAUTION:
• Always be sure that the dust bag or paper pack is
installed properly in the cleaner before use.
Improper installation may allow dust to enter the
motor, resulting in malfunction of the cleaner.
• Always switch off the cleaner after each use to
prevent damage to the cleaner and to lengthen the
service life of the batteries.
This cleaner can be operated in ''standard'' and
''strong'' suction. For standard suction, slide the
switch forward to the LOW position. For strong suc-
tion, slide the switch further to the HIGH position.
To stop the cleaner, slide the switch back to the OFF
position.
q Dust bag
w Hook front cover onto front lip
e Close
r Front lip
Capacity
Battery type
(mAh)
9000 1,200
9002 2,000
9033 2,200
Number of
cells
8
8
8