Cleaning - SilverCrest 60494 Instructions D'utilisation Et Consignes De Sécurité

Setting-up operation / Cleaning
Prob-
No indicator light
lem
on remote control
when pressing "ON"
or "OFF"
Rem- · Check if the batteries are
edy inserted correctly.
· Check if the batteries have
proper contact with the
springs, if necessary
adjust.
Prob- No reaction from
lem consumer
· Check that the appliance
Rem-
edy is switched on.
· Assign new code to the
remote control socket (see
„preparing the remote
control socket", point 3).
· Check - by walking closer
to it - that the range is
correct for the desired
location.
26 GB
Prob-
1
lem
Rem-
edy

Cleaning

Q
J
Ensure that no liquids get into the
inside of the device. Use a soft cloth
to clean the housing. Never use
petroleum, solvents or cleaners
which corrode plastics.
j
Before cleaning, always disconnect
the radio-controlled socket from the
wall socket and remove all power
plugs from the device.
Range is too small
· For large ranges, ensure
that as few walls and as
little furniture as possible
are in the way of the
remote control and the
radio-controlled socket.
· If the range is too small
at times, the reason could
be a remote control which
works on a similar fre-
quency. Whenever this re-
mote control is active, the
range declines (e.g. wire-
less headphones, radio-
controlled movement
alarms, radio gongs
etc.).