Publicité
Les langues disponibles
Les langues disponibles
PD30EM & PD40EM Installation and User manual
Supplied material
The ProxCodoor kit consists of the following parts:
•
The ProxCodoor unit with integrated proximity reader and 20 cm
cable (with connector matching the long cable).
•
Dropbox for connection to Entro.
•
5 metre cable with a 4-pin connector and a free end to be connected
to the dropbox.
•
Extension sleeves for handle nipples (use only one pair).
•
1 reinforcing spring.
•
1 reinforcing spring holder.
Additionally you need some kind of door loop to feed the cable from the
door to the dropbox.
NoTE! No batteries should be mounted in the unit (although there are
cutouts in the back).
Addressing
Before finally mounting the unit the address must be set between 1 - 32.
This is recommended to be done without power (unless the software
might not recognise any change). There are a two rotary switches at the
back of the unit where the arrows indicates the selected digits. If you
have the address switches upwards it looks like the figure.
The address is conformed of two digits:
•
1st digit (left):
•
2nd digit (right):
This will correspond to the address ranges used in the Entro system.
All manuals and user guides at all-guides.com
0 - 3
0 - 9
Publicité
