Publicité
Les langues disponibles
Les langues disponibles
To charge:
Make sure both the charger and mower connections are
clean and free of dirt or debris.
Insert charger plug into charging port on mower, making
sure it is properly connected.
Connect charger to power supply using normal household
current of 120 V, AC only, 60 Hz. The batteries should
automatically begin to charge.
NOTE: The charger is equipped with a plug featuring a
grounding pin and must be plugged into a matching stan-
dard three-prong outlet that has been properly installed
and grounded in accordance with all local codes and
ordinances. Do not use a two-prong outlet, adaptors, or
modify the plug provided. If it will not fit the outlet, have
the proper outlet installed by a qualified electrician.
When powered and connected to the mower, the LED
indicator on the charger will illuminate to indicate the
charger's status. Refer to the operator's manual for the
charger to determine the meaning of the LED's display.
When you are ready to mow, disconnect the charger from
the power supply, then disconnect the charger from the
mower.
NOTICE:
Always turn power switch to off position and remove key
when charging mower and when mower is not in use.
NOTICE:
Always connect the mower to the charger when the unit
is not in use. If it is not possible to leave the mower char-
ger connected, make sure to charge the batteries fully at
least once a month.
SAFETY INTERLOCK SYSTEM
See Figure 7.
This mower features a Safety Interlock System to protect the
operator by shutting off the blades if the operator leaves the
seat with the blades running. Test the system before each
use to be sure it is working correctly.
To test:
Position the mower on a level surface.
Make sure to set the parking brake and blade engage
knob is down.
Install start key and turn to ON position.
Raise blade engage knob to activate blades.
Briefly lift off the seat, but do not get off the mower.
The blades should shut off within 5 seconds. If they don't,
contact customer service. Do not operate the mower until
the safety interlock system has been repaired.
OPERATION
OPERATING THE MOWER
See Figures 8-9.
WARNING:
Clear the area of bystanders before operating the mower.
If anyone enters the mowing area, stop immediately and
do not return to mowing until the bystanders leave the
area.
Before starting the mower:
Ensure work area is clear of children, bystanders, and
pets.
Clear the work area of objects that may be thrown by the
mower blades.
Check brake operation.
Check tire pressure.
15 — English
Fig. 7
FORWARD MOWING
Fig. 8
Publicité
