Miele CS 1011 Instructions page 18

Converting CS 1028
After conversion
^ After converting the cooktop, affix the
label supplied with the conversion kit
on to the data plate over the type of
gas stated.
^ Reassemble the burner parts in the
reverse order.
^ Check all gas fittings for leaks by
operating the burner without the
combiset surface in place (use a
match to ignite the flame).
^ Remove the loose burner parts again.
^ Replace the combiset surface.
^ Screw the burner base into place,
and replace the other parts of the
burner. Take care to reassemble the
burner in the correct order.
^ Replace the control knob.
^ Light the burner to be sure it is
operating correctly.
When set at "low" or when the control
knob is quickly turned from "high" to low
the flame should not go out.
When set at "high" the gas flame must
burn with the center clearly visible.
18
All manuals and user guides at all-guides.com