Panasonic EY7411 Instructions D'utilisation page 11

● The light will automatically turn
off if the drill is not used for 5
minutes.
● The light uses an extremely small
amount of current. Using the light
has a negligible effect on the
operational capacity of the drill.
● The LED is incapable of lighting
the tip of the bit when the drill is
used in the straight configuration.
 Bit­locking Function
With the switch at off and the bit lock-
ed in place, the tool can be used as a
manual screw-driver - up to 14.7 N·m
(150 kgf-cm, 130 in-lbs).
There will be a little play in the driving
shaft, but this is not a malfunction.
 Main Switch (ON/OFF)
Push the upper half of the switch for
forward rotation, or the lower half for
reverse rotation.
EY7411(UL).indb 11
Forward
Reverse
 Speed Selector Switch
To suit the application of this tool, two
different rotational speeds are avail-
able. Depending upon use, either the
high or low speed should be select-
ed.
HIGH
Speed selection
LOW 00 min
HIGH 600 min
CAUTION:
• Check speed selector switch before
use.
• Do not operate the speed selector
switch while the main switch is on
(switch is in the ON position).
 Main Switch Lock
After use, set the main switch lock at
the lock position to prevent accidental
operation.
Main switch lock
 Battery Pack (EY9L10)
CAUTION:
1. Remove the battery pack away from
the tool.
. Charge the battery pack using the
battery charger.
- 11 -
Forward
Reverse
LOW
Torque
(rpm) High
-1
(rpm) Low
-1
Lock
2007/01/15 13:39:24