Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation instructions
Step 4. Installing the power cord
For power cord installations, hook the strain relief over the power cord hole (1⅜")
located below the rear of the drawer body. Insert the power cord through the
strain relief and tighten the device.
Conduit connection
plate
Power cord
Strain relief
•
You must install the power cord with a strain relief.
•
Attach the strain relief to the 1⅜" opening in conduit connection plate.
Installing a 3-wire power cord
WARNING
The neutral or ground wire of the power cord must be connected to the neutral
terminal located in the center of the terminal block. The power leads must be
connected to the lower left and the lower right terminals of the terminal block.
18 English
Install_NY63T8751S_DG68-01305A-01_EN+CFR.indb 18
1.
Ground strap
Neutral
White
terminal
2.
Black
Red
3.
White
Black
Red
4.
Remove the 3 lower terminal screws
from the terminal block.
Insert the 3 terminal screws through
each power cord terminal ring and into
the lower terminals of the terminal
block. Be certain that the center wire
(white/neutral) is connected to the
center lower position of the terminal
block.
Tighten screws securely into the
terminal block. DO NOT remove the
ground strap connection.
Go to step 6 on page 21 and proceed
with the installation.
2020-07-20
4:47:32
Publicité
Table des Matières
