Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
15.3
Connecting the device
1.
Connect the cable to a USB port of your computer.
2.
Use the needle to gently press and hold the reset button on the
device, as shown.
3.
While holding the needle, plug the micro USB cable to the USB
OTG port of the device.
4.
Remove the needle after 3 to 5 seconds.
The next steps depend on the operating system you are using. The
manual describes the steps for Windows XP (next section) and
Windows 7 (page 19).
15.4
Windows XP
On your computer, the following window will open:
V. 02 – 12/09/2013
PCTV2
16
©Velleman nv
Publicité
Table des Matières
