Mitsubishi Electric JT-SB216JSH-W-E Mode D'emploi page 23

(8) Switch (assembly) (with a thermal fuse)
1 Remove the terminal block fix plate from the side panel (left).
→ See (7) 1 to 7.
2 Remove the power switch lead wires (brown and blue) from the ter-
minal block. (Indicated by )
3 Unscrew the clamping screw, and remove the terminal block.
(One PTT screw 4×6, indicated by )
Assembly precautions
• Take care not to pinch the lead wires.
• Hook the claw of the terminal block fix holder to the terminal block
fix plate. (Indicated by )
4 Unscrew the clamping screw, and remove the switch fix piece and
the switch (assembly).
(One PPT screw 3×8, indicated by )
Assembly precaution
Hook the claw of the switch fix piece to the terminal block fix plate.
(Indicated by )
For JT-SB216JSH-W/H/S-E
(9) Heater (PTC)
1 Remove the side panel (left). → See (7) 1 to 5.
2 Unscrew the side panel (right) clamping screw.
(One PTT screw 4×16, indicated by )
3 Remove the side panel (right) in the direction of the arrow.
Assembly precaution
Fit the side panel (right) into the groove of the panel (back) and the
base. (Indicated by )
Assembly precaution
Run the lead wires through the groove of the base. (Indicated by )
─ 23 ─
Terminal block
Terminal block
fix holder
Switch fix piece Switch (assembly)
Terminal block fix plate
Side panel (right) Panel (back)