Selecting The Temperature; Switching On The Fan - SilverCrest SKD 2300 B2 Mode D'emploi

Selecting the temperature

GB
IE
Select heat setting
The heat setting determines how quickly the appliance warms up.
The appliance has three heat settings:
■ Level 1: 1000 watts
■ Level 2: 1300 watts
■ Level 3: 2300 watts

Switching on the fan

The appliance has a fan which can be used to distribute heated air throughout
the room more quickly.
14
All manuals and user guides at all-guides.com
NOTE
► The display shows the set target temperature
2
temperature .
20
► The temperature measurement is made by the temperature sensor
may take some time until the whole room has reached this temperature.
♦ Press the button or
23
temperature display uses °C or °F.
The selected unit of measurement
♦ Press the "Increase temperature" button,
temperature up to a maximum of 37°C (99°F).
19
The selected target temperature
♦ Press the "Decrease temperature" button,
temperature down to a minimum of 5°C (41°F).
19
The selected target temperature
♦ Press the button to select the heat setting
desired heat setting has been set.
The selected heat setting
♦ Press the fan button 14
If the fan is running, the "Fan" symbol
NOTE
► If the fan is switched off, the heat is concentrated more around the appli-
ance and is not distributed so quickly around the room.
28 to select the unit of measure, to select whether the
13 is shown on the display
or
15 32
is shown on the display
19
or
16
is shown on the display
19
or
24
10
is shown on the display
or to switch the fan on or off.
27
11 appears on the display
and measured actual
19
. It
7
.
2
, to increase the target
.
2
, to decrease the target
29
.
2
repeatedly until the
26
.
2
.
2
SKD 2300 B2