Operation; Preparation; Toasting - Beko BKK 3025 EK Manuel D'utilisation

3

Operation

3.1 Preparation

1. Remove all packaging and sticker materials and
dispose of them according to the applicable
legal regulation.
2. Before using the appliance for the first time,
clean the appliance (See the "Cleaning and
care" section).
3. Make sure that the appliance is sitting in an
upright position and on a stable, flat, clean, dry
and non-slip surface.
Note
• When using the appliance for the first time,
smoke can develop due to production residues.
However, this does not mean the appliance is
defective. The first time you switch it on, use the
appliance as you normally would, but without
bread. It is recommended to use the medium
setting of the browning control
Ensure for proper room ventilation.

3.2 Toasting

1. Insert only one slice of bread in each of the two
bread slots .
C
2. Connect the power plug into the wall socket.
3. Using the browning control
degree of browning.
Notes
• Pushing the browning control to the left will give
the lightest degree of browning and to the right
the darkest. The browning degree can vary de-
pending on the type of bread.
• When toasting several slices of bread consecuti-
vely, the toaster will become hotter and therefore
the bread will gradually become darker. The-
refore select an appropriate browning degree.
Let the toaster cool down after each toasting
process for minimum 30 seconds.
• The degree of browning of one slice is darker
than two slices, although the browning control
is set to the same level.
J
8 / 33 EN
All manuals and user guides at all-guides.com
• Press the start lever
4. The toasting process begins. The indicator light
Notes
• If the power plug is not connected into the wall
• The degree of browning can also be adjusted
5. The appliance automatically switches off as
to burn in.
J
Notes
• To cancel the toasting process before it has
• After the start lever
select the desired
J
Caution
• Be very careful when taking the toast slices out
6. Disconnect the appliance from the wall socket.
• If toast slices get stuck in the toaster, switch
down until it automati-
F
cally snap into place.
of the stop button illuminates during the
G
toasting process.
socket, the start lever
F
place.
during the toasting process with the browning
control .
J
soon as the set degree of browning has been
reached.
– The start lever springs back up and the
F
stop button light goes off. The toast slices
G
are pushed upwards and can be taken out of
the toaster.
finished, press the stop button
springs back up and the toast slices can be
F
taken out of the toaster.
springs back up, you can
F
use high-lift function by pushing the start lever
upwards.
F
of the toaster as the metal parts of the toaster
and also the bread can become very hot.
the toaster off immediately by pressing the stop
button . Pull the power plug out of the wall
G
socket. Let the toaster cool down completely.
Carefully try to take the bread out of the toaster
without damaging the sensitive heating elements
and other parts. Do not use any electroconduc-
tive objects to remove the bread from the toas-
ter.
does not snap into
. The start lever
G
Toaster / User's Manual