Event List; Reset Default; Functions - Velleman VQC4 Notice D'emploi

• MOTION SET
CAM: camera number
SELSENS: minimum cell number to trigger alarm
LVSENS: cell sensitivity (00 ~ 15, the smaller the more
sensitive)
REFFLD: real-time refresh (NO/YES)
SPEED: moving speed of the object
TMPSENS: refresh rate
SPSENS: moving distance refresh rate
Set the motion detection area and confirm with ENTER.
Use ▲, ▼, + or – to move the cursor down, up, left or
right. Press ENTER to select/delete a green cell (valid motion detection area). Press MENU to save and exit.

• EVENT LIST

NO: event number (001 ~ 100)
CAM: camera number
DATE: event date
TIME: event time
EVENT: event cause (LOSS: video loss, MOTION:
motion detection, P_ON: opening record)
PREVIOUS: previous page (press ENTER or ▲ to
select the previous page)
NEXT: next page (press ENTER or ▼to select the
previous page)
ERASE: erase all records and start from 001

• RESET DEFAULT

To restore to the factory default settings, select YES
and press ENTER to confirm.

5. Functions

• Video Loss Alarm
The alarm will ring when the video signal is lost. The
monitor will display LOSS and the indicator will flash. The alarm will turn off after pressing a key.
• Motion Detection Alarm
The alarm will ring when a motion has been detected. The monitor will display MOTION and the indicator will
flash. The alarm will turn off after pressing a key.
• Confirming an Alarm
When the alarm rings, press any key to stop the alarm. Press the corresponding channel button to erase the
alarm message.
VQC4
- 5 - VELLEMAN