Initializing A Cd-Rw Disc - Yamaha CDR-HD1500 Mode D'emploi

Initializing a CD-RW disc

This operation initializes a CD-RW disc.
1.
Set a CD-RW disc in the disc tray, then press and
hold ERASE for about two seconds.
"Erase Disc ?" appears on the display.
E r a s e D i s c ?
To cancel erasing, press a.
2.
Press w/d to start erasing.
"Erasing" flashes on the display, and the level meter shows the
erasing progress (the process takes about 20 minutes).
Notes
• "Erase Last" and "Erase TOC" cannot be applied to a CD-RW
disc recorded with "Full Auto" (P.42) (except for adding track
data to a disc without finalization) or a CD-RW disc recorded
with duplication.
• Never turn off the power of this unit during erasing.
• If "Check Disc" appears on the display during erasing, and
erasing stops, there may be dust or damage on the CD-RW disc.
Check the CD-RW disc and start the erasing operation again.
L
dB –30 –10 –6 –2 0
CDRW
R
ERASING DATA ON A CD-RW DISC
4
49