Accessories; Technical Data - Black & Decker PRO Serie Mode D'emploi

Accessories

The performance of an electric tool depends on its
accessories. Black & Decker accessories are designed
according to high quality standards, to enhance the
performance of electric tool. The use of these accessories
can help you conveniently operate the tool.
Maintenance
The Black & Decker cord / cordless appliance / tools are of
sophisticated design, can be used for a long time, and only
little maintenance is needed. To obtain consistent
satisfactory use, proper maintenance and regular cleaning
of the tools are necessary.
Warning! Before performing any maintenance work on the
cord / cordless electric tools, the following points must be
implemented:
• Switch off the power of the equipment / tools and pull off
the plug;
• If the equipment / tools are equipped with independent
battery pack, please turn off the power and remove the
battery pack from the equipment / tools.
• If the equipment / tools are equipped with an integrated
battery, please run out the battery, before turning off its
power.
• Before the cleaning, unplug the charger plug from the
power source. In addition, except the regular cleaning on
your charger, no other maintenance is needed.
• Regularly use the soft brush or dry cloth to clean the
ventilation slot of the equipment / tools / charger.
• Regularly use a damp cloth to clean the motor housing.
Please do not use any abrasive cleaning agents or
solvent-based cleansing agents.
• Regularly open the clamping chuck and tap it gently to
remove any internal dust (after installation).
Cleaning
Warning! Once the visible dust build-up is found
at and/or around the ventilating ports,
immediately flush the dust and powder within the
host shell with clean dry air. To perform this
procedure, wear the approved safety equipment and dust
mask.
Warning! It is strictly forbidden to clean the
non-metallic parts of the tool with the solvents or
other irritant chemicals. These chemicals may weaken the
materials of these components. Use a cloth moistened with a
mild soapy water to clean it. Do not let any substance
permeate into the tool and.do not immerse any part of the
tool into a liquid.

Technical data

Impact Drill
Power input
Voltage
Frequency
No-load speed /min
Impact rate IPM
Reverse/Forward rotation
Chuck capacity mm
Max capacity
o C r c n e t e mm
Metal mm
Wood mm
Weight
ENGLISH
BPDH7213
W 720
V 220-240
Hz 50/60
0-3000
0-54000
Yes
1.5-13
16
13
32
kg 2.5
9