Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Stand steamer on its base and allow it to completely
cool off before storing. (G) To avoid mineral buildup,
empty the tank after each use.
STE AM CLEANING IN THE HOME
Using steam to clean household items that can tolerate hot,
damp steam without damage is non-toxic, and inexpensive.
This cleaning method is beneficial to those sensitive to
chemical cleaners or trying to reduce chemicals in the
home. Steam upholstery, draperies, linens and home
textiles to clean and refresh.
CL EANING AND CARE
This product contains no user serviceable parts. Refer to
qualified service personnel.
CLEANING STEAMER EXTERIOR
1.
Make sure steamer is unplugged and completely cool.
2.
Wipe the ironing plate and outer surface with soft, damp cloth. Water
and small amounts of gentle household soaps, such as dishwashing
liquid, can be used on the exterior. Never use heavy-duty cleaner, or
abrasive scouring pads that may scratch or discolor the steamer.
3.
After the steamer has been thoroughly dried, turn it back on and lightly
steam over an old cloth. This will help remove any reside left in the
steam holes.
4.
Unplug, empty tank, and allow time to cool before storing.
STORING THE STEAMER
1.
Check that the steamer is unplugged and completely cool.
2.
Wrap the cord loosely around the base of the steamer.
3.
Always store steamer upright on its base to prevent water leakage.
Tip: Emptying the tank after each use is recommended because standing
water can leave a residue over time.
STE AMI NG T IPS A ND TR IC KS
•
This steamer is designed to use distilled, purified, or filtered water. Tap
water contains minerals that build up. Using water with perfumes or
scented additives is also not recommended.
•
Always test garments by steaming a small hidden area to make sure the
garment takes well to steam.
•
Always read garment care label instructions. Fabrics suitable for mid to
high heat can be pressed with the ironing plate.
F
G
6
•
Small amounts of dripping might occur during use. If excessive, either
the steamer needs time to get back up to full temperature or there
could be a build-up of condensation on the ironing plate. Just allow the
steamer a minute to reheat, or gently wipe the ironing plate against the
ironing pad fabric to remove condensation.
•
To prevent iron marks on fabric, turn garment inside out before using
the ironing plate. Sensitive items (such as items with embellishments)
should be steamed inside out as well to avoid damage.
•
Putting on a garment immediately after ironing or steaming can actually
create wrinkles. Always allow clothing to cool for about 5 minutes after
ironing or steaming to set the press.
T ROU BL E SHO OTI NG
Problem
Possible Cause
The steamer is plugged
There's a power supply issue.
in but not heating.
Not enough steam or
The steamer isn't heated up
to full temperature.
no steam is coming out
There is not enough water in
of the steamer.
the water tank.
The steamer has not been
used for several weeks or
more and an air pocket is
blocking the steam.
Discolored water is
Residue has built up in the
water tank or on the ironing
coming through the
plate.
holes and staining the
Perfumed or scented
fabric.
additives were used.
Starch was used.
Steamer is leaking or
Steamer is not hot enough.
spitting.
Condensation has built up.
Water tank is running low.
If additional assistance is needed, please contact our consumer service team at
1-800-465-6070.
Solution
Check that the plug is
properly inserted into the
outlet or try plugging the
steamer into a different outlet.
Always allow steamer to
preheat at least 60 seconds.
Follow the instructions under
the "filling the water tank"
section and fill to Max level
marker.
Push the "steam reset"
button on the bottom of the
unit. The steam reset button
pushes air through the pump.
Empty the water tank after
each use. Only use distilled,
filtered, or purified water.
Regularly clean steamer and
refrain from using perfumed
or scented additives.
Always clean steamer ironing
plate after using starch.
Allow the steamer to heat for
about 45 seconds.
Gently wipe the ironing plate
with a soft, damp cloth to
remove condensation.
Follow the instructions under
the "Filling the Water Tank"
section and fill to Max level
marker.
7
Publicité
Table des Matières
