Table des Matières
Publicité
Getting started
2
After fully charging, unplug the USB cable from the battery pack, and then
disconnect it from the electric socket.
To save energy, unplug the charger when not in use. The charger does not
have a power switch, so you must unplug the charger from the electric
socket when not in use to avoid wasting power. The charger should
remain close to the electric socket and easily accessible while charging.
Checking the remaining battery power
Check the remaining battery power by pressing the Battery Level
button. The indicator lights alerts you to the remaining battery
power.
Remaining
battery power
75–100%
50–75%
25–50%
5–25%
0–5%
Using the battery pack
Charging the mobile device
1
Connect one end of the USB cable to the battery pack's USB charger port.
Then, plug the other end of the USB cable into the mobile device's
multipurpose jack.
Indicator light status
Four indicator lights on
Three indicator lights on
Two indicator lights on
One indicator light on
One indicator light blinking
English (USA)
5
6
4
Publicité
Table des Matières
