Defi Nitions: Safety Guidelines; Tools Required - DeWalt DW7231 Guide D'utilisation

Defi nitions: Safety Guidelines
The definitions below describe
for each signal word. Please read the manual and pay attention
to these symbols.
DANGER: Indicates an imminently hazardous situation which,
if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, if
not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if
not avoided, may result in minor or moderate injury.
NOTICE: Indicates a practice not related to personal injury
which, if not avoided, may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR
ANY D WALT TOOL, CALL US TOLL FREE AT: 1-800-4-D
E
(1-800-433-9258)
WARNING: For your own safety, read the miter stand
instruction manual before using any accessory. Failure to
heed these warnings may result in personal injury and serious
damage to the miter stand and the accessory. When servicing
this tool, use only identical replacement parts.

Tools Required

• Drill with 3/8" (9.5 mm) drill bit (Not required for D
Saws)
• Crosshead #2 screwdriver
• 1/2" (13 mm) Wrench
General Safety Instructions for Stand
Accessories
the level of severity
WARNING: To reduce the risk of personal injury:
• ALWAYS use eye protection. All users and bystanders must
• ALWAYS check the stability of the miter saw stand and the miter
• DO NOT mount any power tool other than a miter saw to this
• DO NOT exceed the weight these brackets can hold. Each
• Follow the mounting instructions carefully. Fasten the miter saw to
WALT
E
• DO NOT modify or use stand for operations for which it is
• DO NOT use the stand on uneven surfaces. The stand is designed
• DO NOT use on a slippery surface. The stand load capacity is
Components (Fig. 1)
WARNING: Never modify the stand or any part of it. Damage or
WALT Miter
E
personal injury could result.
Refer to Figure 1 for Components List.
1
wear eye protection that conforms to ANSI Z87.1.
saw attached to it before putting the stand or the saw into use.
stand. Mounting other power tools to this stand could result in
severe personal injury.
bracket can support up to 250 lbs. (113 kg) when loaded directly
over the stand main beam. Do not exceed weight rating of the
stand.
the saw mounting brackets securely as instructed.
unintended.
to be used on a flat, stable surface.
greatly reduced when used on slippery surfaces.