Connecting Cable Or Satellite With A Set-Top Box - HP Pavilion Serie Mode D'emploi

mb5ltvsh.book Page 15 Monday, June 27, 2005 1:58 PM
Removing CableCARD
1
Turn on the TV; see "Turning the TV On and Off
(Standby)" on page 27.
2
Check that the CableCARD upgrade screen is not
displayed. If it is displayed, wait until it
disappears.
3
Check that the OPC light on the front of the TV is
NOT red; see "Turning the TV On and Off
(Standby)" on page 27. If it is red, wait for the
OPC light to change or go out.
4
Remove the CableCARD.

Connecting cable or satellite with a set-top box

Connecting your TV directly to the audio and video
output of your set-top box assures a more vivid picture
and enhances your viewing enjoyment.
Optional equipment and all cables are sold separately.
You can connect a digital TV set-top box (air or cable)
and other audiovisual equipment by using:
Input 1 terminals with either component or
■
composite video connections
■ Input 2 terminals with either component or
composite video connections
Input 4 terminals with HDMI connection
■
Input 5 terminals with DVI connections
■
If your cable TV company has CableCARD
available, you can also use the CableCARD
to receive HDTV programs. See "Using a
CableCARD" on page 13.
CAUTION: Unplug power for the TV and all
connected components before connecting
the set-top box.
n
c
Disconnecting the cable antenna when
using CableCARD
1
Turn on the TV; see "Turning the TV On and Off
(Standby)" on page 27.
2
Check that the CableCARD upgrade screen is not
displayed. If it is displayed, wait until it
disappears.
3
Check that the OPC light on the front of the TV is
NOT red. If it is, wait for it to change or go out.
4
Disconnect the cable antenna.
For more information about CableCARD, refer to
"Using the CableCARD Menu" on page 62.
1
Connect the set-top box input source cable(s) to
the back of the TV using one of the terminals sets.
Input 1 (A) or Input 2 (E) using component
■
connections. (Input 1 shown.)
A
B
C
D
E
15
Setting Up