Battery Pack And Charging Procedure - Yamaha PW-X Notice D'utilisation

22
G. Battery pack and charging procedure
Charging plug
Power plug
Battery
capacity
indicator
Charging connector
The battery pack equipped for the Yamaha e-Bike Sys-
Battery charger lamp
tems is a lithium-ion battery. The lithium-ion battery is
lightweight and offers superior capacity. However, it does
have the following characteristics.
• Its performance decreases in extremely hot or cold en-
• It naturally loses its charge.
Charger
The battery pack for the Yamaha e-Bike Systems also has
display
an embedded computer which notifies you of estimated
residual battery capacity and suspected faults via the bat-
tery capacity indicator lamp.
Battery capacity
By pressing the battery capacity indicator button, you can
indicator lamp
display the residual battery capacity for approximately 5
seconds.
See "Checking the residual battery capacity" for the esti-
mate of the residual battery capacity. See "Troubleshoot-
ing" for information on fault flashing.
Do not use any other charger or charging method to
Battery capacity
recharge the special batteries. Using any other charg-
indicator button
er could result in fire, explosion, or damage the bat-
teries.
IMPORTANT SAFETY INSTRUCTIONS — SAVE THESE
INSTRUCTIONS
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, CAREFULLY FOLLOW THESE INSTRUC-
TIONS
This manual contains important safety and operating
instructions for battery charger Type PASC4.
Before using battery charger, read all instructions and
cautionary markings on battery charger, battery and
product using battery.
Only use it to charge PASB4 type batteries for
Yamaha e-Bike Systems. Other types of batteries may
burst causing injury to persons and damage.
NOTICE
Do not apply grease on the terminal of the battery.
vironments.
WARNING
WARNING
34