Publicité
Les langues disponibles
Les langues disponibles
15 Attach the butyl rubber tapes on the inside of the
grille.
Attach the eight butyl rubber tapes
to each grille, lining up the butyl
rubber tapes to the marks on the
inside of the grille.
Then peel off the protective paper.
16 Attach the grille to the speaker.
The grille is designed with a specific mounting
orientation. Gently push the grille onto the speaker, lining
up the one section of the edge of the grille to the groove
in the speaker. Then line up the entire grille to the groove
in the speaker and attach the grille by pressing in all
around the edge.
Orientate the grille so that the
notch is positioned adjacent to
the ELITE logo.
Make sure to press on the
edges. Pressing on the
middle of the grille will
cause it to be deformed.
• Once you have pushed it in, make sure you press it
firmly against the speaker so that the grille doesn't
fall off and cause an accident.
• To remove the grille, use the supplied tool to hook
into the holes located near the edges and pull the
grille out. When doing this, make sure to pull the
edges out evenly. Forcing the grille out from one edge
alone will cause the grille to be deformed.
6
En
Connections
Connecting to an amplifier
Make sure you have read the connection instructions in
the manual supplied with the amplifier and that all
equipment is turned off before making any connections.
• When using a set of speakers connected to an
amplifier, you won't be able to obtain the correct
stereo effect if the polarity (+, –) of one of the
speakers (left or right) is reversed.
Additional Information
Cleaning the speaker
Use a dust brush to wipe off dust and dirt.
Never use furniture wax, cleaners, thinners, benzine,
insecticide sprays or other chemicals on or near the
speakers, since these will corrode the surfaces.
Publicité
